Through the use of numerically controlled work center with 5 axis, the panels can be cut, drilled and milled post-production, creating pleasant scenic effects and further expanding the cladding finishings possibilities.
The external finishing of CLADIA® panels with Ductal® inside, can be provided with an innovative technology thanks to which, on the external surface, can be reproduced any kind of digital imagine to further customize the curtain wall of the buildings.
3 standard size
1200 x 1200 mm
1200 x 2400 mm
1200 x 3600 mm
± 2 mm
Lower dimensions are possible; they are obtained from cutting standard-side panel (excluded scraps).
On demand no-standard.
Cross curvature tolerances
Vertical curvature tolerances
± 1 mm
± 0,05 %
± 2 mm / m
1/200 of the width
1/200 of the length
Keil point fixing and de-moulding
15 mm = 35 kg/m2
>14Mpa (according to EN 14617-2)
E cm >44 GPa
A1 (according to EN 13501-1)
Prove e certificazioni
ATEX tipo A rilasciata
da CSTB (Francia)
Effect of material
Processing the surface with evidence of microgranules
Traditional mechanical processing
Hammered rounded and bush hammered processing
orange peel appearance standard matrix and photographic material
on demand to customer specification
It is a fastening system with special rivets which allows a really fast mounting and a long durability over time. The fastening with mobile and fixed points permits the thermal expansions of all used materials
It is an exposed fastening system which allows to screw the panels to the vertical mullions.
Using hidden clips, fastened at the rear of the panels and at special dowels; there are no-exposed elements. .
KEIL SYSTEM FASTENING
There are different solutions to realize angle linking as reported below.